The tracks will arrive on a pallet rolled up into four sections.  You will need to bolt two of the sections together, then lay them out.  Carefully drive onto them, stop at the half way point.  Roll them up over the front and rear of the tires, then use a ratchet strap to pull them together.  Each link in between pads have two holes for adjustment.  Tracks should sag in between tires approximately 1" - 3".  Place a 2x4 or straight edge across the top of the track and measure between the 2x4 and top of the track to determine the proper sag.

Machine requirements are that you have 3" of clearance between the machine and the inside of the tire.  We do sell wheel spacers if they are needed at additional cost.  Few older machines require a 3/4" boom stop to keep boom arm from touching tracks.

MADE IN USA